In this first lesson you will go through the process of unboxing your computer on module and carrier board and assembling the hardware.
A block diagram of the system setup and its connections is presented below for reference.
The following table lists the items required:
|List of items required|
|VGA display/monitor and DVI to VGA adapter|
|Accessory kit :|
|- 12V 30W power supply|
|- USB-Serial converter|
|- IDC to DB9 adapter cable|
|- Ethernet cable|
As an option to buying the IDC to DB9 adapter, you might assemble one by following the instructions provided here.
Note: The DVI video output is configured to provide an analog signal by default in the Colibri family. Please make sure that your DVI adapter has the analog pins available - see DVI-A or DVI-I for more details.
Remove the Iris Carrier Board and the Colibri Computer on Module from the blisters. Insert the computer on module into the X1 connector of the Carrier Board as tight as possible, with the module inclined ~30 to 45 degree in relation to the carrier board.
Warning: Make sure that the module is well connected to the carrier board. The image below has some checkpoints highlighted.
Connect the DB9 to IDC adapter cable to the X13 connector on the Iris.
Note: The adapter is included in the Toradex Cable Kit, the standard we used is normally called DTK or Intel standard.
Connect your host machine to the adapter cable using a serial cable or Serial to USB converter.
Connect the VGA display/monitor to the X4 connector through the DVI to VGA adapter. Note: The DVI output only has the analog signal enabled by default. To use the digital interface please refer to the FAQ section in the end of this lesson.
Connect an Ethernet cable to X15. Note: Ethernet network must provide DHCP and Internet to the module.
Connect a USB keyboard to X11.
This FAQ section is meant to provide additional information for the getting-started readers, therefore it may be skipped without prejudice to the progress of the guide.