In this first lesson you will go through the process of unboxing your computer on module and carrier board and assembling the hardware.
A block diagram of the system setup and its connections is presented below for reference.
The following table lists the items required:
|List of items required|
|Accessory kit :|
|-12V 30W power supply|
|-USB Type-B to Type-A cable|
|USB keyboard and mouse|
|2.4GHz SMA antenna|
|SMA to U.FL cable|
Remove the Evaluation Board and the Colibri Computer on Module from the blisters.
Unpack the SMA antenna and the SMA to U.FL cable.
Connect the SMA antenna to the SMA to U.FL cable as shown in the picture below:
Connect the antenna to the U.FL connector on the Colibri iMX6ULL module as following:
Insert the computer on module into the X1 connector of the Evaluation Board as tight as possible, with the module inclined ~30 to 45 degree in relation to the carrier board.
Warning: Make sure that the module is well connected to the board. The image below has some checkpoints highlighted.
Attention: Double check that your power supply is within the Evaluation Board limits (7-27V) and that the polarity is not inverted. Also, make sure that the current capability of the power supply is enough, or the system may shut down unexpectedly. For evaluation purposes, a 12V 2A power supply is recommended.
VGA, Ethernet, USB keyboard, power supply and USB Type-B to Type-A cable connected to the Evaluation Board
Make sure that the jumpers JP19 and JP17 are set to USB mode as shown in the image below, once we will use UART A via the USB Type-B connector X27.