In this section, you will power on your system and use the Toradex Easy Installer to flash the latest Toradex pre-built image to your module.
In this module you will:
Press the on/off switch (SW7):
You should see the Toradex Easy Installer displayed on the monitor attached to the VGA port of the Colibri Evaluation Board. Images available for download are listed. If none are currently shown, check that the Ethernet cable is connected and press "r" to refresh.
Your module should have come with the Toradex Easy Installer pre-installed.
If this isn't the case, you can follow the link below to deploy the Toradex Easy Installer to the module before proceeding:
Use the connected keyboard arrow key buttons to navigate and select the Toradex Embedded Linux Demo with LXDE and press "i" to install and enter to confirm:
Note: While executing this step make sure your board is connected to internet source and connection is established successfully.
Wait for the image to be downloaded and installed:
After the Image Installed message pops-up, use the on/off button or select the Power off option to shutdown the system.